new walker questions
Hey oneshot here had to finally do it and grab a new 2017 walker mt efi t 25i. I am having a little issue with it thought. the machine has had several hard starts. meaning turn the key three times to...
View Article24HP Vanguard oil capacity
24HP vanguard on my newerish 52" wright stander X I lost my manual and have searched online with conflicting/vague results. One site says 48oz. next says 64oz and the other site gives me a "range" I'm...
View ArticleHS82T bogs down, dies
ive had my stihl hs82t since probably May, used it maybe 7-8 times for a probably less than 24 hours total, still looks brand new. I had it out today and it would run for 5 minutes, I'd hear it start...
View ArticleProblem shutting off vanguard engine
Hi Everyone, Having an issue with one of my vanguard engines on a snapper walkbehind hydro. When the key is turned to the 'off' position, the engine runs very slightly rougher, but doesn't shut off. I...
View Article257-H Kawasaki FC540V Fuel Filter
I own a Wheel Horse 257-H with 17HP single cylinder Kawasaki FC540V that does not have a fuel filter. Is there any reason why I can not just cut the fuel line in two and add one? Where is the best...
View ArticleFerris 3200z misfires/ backfire when cutting grass
Mower runs fine until I engage blades. Then it backfires and rpms drop to about zero and it about dies. Any ideas what could be wrong? Thanks
View ArticleKohler 23HP with bent push rods?
My '05 Exmark with 23 HP Kohler bent the push rods. After inspection and not finding a good reason for it but replacing the coils and checking for stuck valves etc, we put new ones in and within 30...
View ArticleSmall mower with rear castors?
I have a tree farm. 12 acres of narrow aisles, demo areas. I use a grasshopper 725 D with 5 foot deck for most of it. Currently I use a weedeater to do the trim in the demo garden. I've used my husky...
View ArticleDixon engine problem
I am told that this needs to be directed to Jim Q. I have a 2006 Dixon Kodiak with failed engine. 1. intermittent engine temperatures between normal and 220 deg. F. Added coolant which was low. 2....
View ArticleGrasshopper 225 won't start!
Son was mowing came in for a drink went back out to start and nothing. Checked pto etc, brake, seat switch, fiddled with the arms. Nothing. Replaced ignition switch, because start fuse was fried,...
View ArticleReplace Spring on Tension Pulley
I hope this is appropriate for this forum. I have a new Kubota ZD326 with only 35 hours. The spring on the tension pulley for the belts, broke. My local dealer gave me a new spring, but no advice on...
View ArticleWalker Fuel solenoid problem... HELP!
2007 Walker MT with Kohler 23hp. Battery was about dead so I jumped it... ran fine for half a day, and then just quit. Jumped again, and it would start but then shut down in about 3 seconds. Thinking...
View Articlekawasaki 23 HP engine does not start when warm
Hi there, I am posting this hoping one of you has come across this before and I can avoid a repair bill. I have a kawasaki 23 HP FH680V that runs flawlessly, starts fine when cold, but if it warms up...
View ArticleWhat is the "spacer" for on a Stihl br600 blower?
i picked up a relatively good used br600 that did not have the black spacer over the muffler that is mounted in the shroud cover. I see in the manual it specifically calls out that it should be...
View ArticleKawasaki fc420v spark tester woes
hey guys. So I have a Kawasaki fc420v-cs06 on a bobcat / ransomed walk behind. It's ran perfect for years. Starts second pull. Went to mow today and nothing. Wouldn't start. Check fuel and spark and...
View ArticleKohler sv720 start problem
Hello lawnsite! Long time, no post. I picked up a Toro GT 2100 a couple of months ago as a refurb from HD. It beats the old snapper hands down, but I've been having some starting problems. Please note...
View ArticleWalker deck size and blade length confusion
Again I'm in need for some insight, my Walker is driving me nuts. As I bought this '09 MD unit I was told it has a 48" deck, I measured the width and it is approx 49" something. So I ordered 25" blades...
View ArticleHELP! ASAP! Buying this z71 later today!
Im going back and forth. This '06 silverado z71 looks great in EVERY way except this... i need some opinions on the undercarriage. I took a ballpeen hammer to a lot of different areas and nothing broke...
View ArticleReplacement Motor
Hey guys so I've got the chance to purchase a John Deere GX1320 38" for $350. Now because I'm getting it really cheap I'm thinking of replacing a lot of the parts and maybe even the motor. I was...
View ArticleEcho srm 280 woes
I have a srm 280 echo 2 years been running great until a few days ago. Every time i open it up it bogs. I put fresh gas in check the exhuast and plug all were good. Then i looked around and saw there...
View Article