Tecumseh ohh 60 on a tiller carb problems
I installed a new aftermarket carb and now it acts like it runs out of fuel. You can hit the primer and keep it going. I have good fuel flow from the tank to the carb.
View ArticleToro 5200D stalling
It idles fine and will creep forward and reverse ever so slightly when you push the direction control. Once it starts to move the machine dies, like the parking brake is set...where is the brake switch...
View ArticleGas leak on cap?
My Classen aerator seems to be leaking from the cap. It happens when aerating, transporting, and especially when on hills or tipped over. I'm wondering if I'ts just a design flaw or if the cap is old.
View ArticleZ930R Deere pto
I have a two year old z930r that the deck doesn't always engage. It started a week ago sometimes it works fine, next time it wont engage. If it wont engage the diagnostic light comes on. I assume its...
View Article2015 Scag Vride 61in 25.5hp electical issue?
Went to put the mower back on the truck and it wouldn't turnover. When I would turn the key I could hear it click a little but that's it. I checked all the safety connections,PTO, and smacked on the...
View ArticleeXmark/Kohler stator problems
Hello, On my eXmark Lazer Z I need to get to the stator to either replace or possibly make a repair, How difficult is it to get to it and any suggestions/tips/advice/on how is the best way to do it,...
View ArticleJacobsen HR 5111. Deck won't lower
Hi. I recently replaced a hydraulic hose from the left lift cylinder to the raise and lower lever for the left deck. The deck now will not lower and raises real slow. Is there a possibility of air....
View ArticleToro Proline 36 not cutting evenly
Hello all, Just thought I would throw this out and see if anyone else has this issue. I have an older 36 proline that was my first mower. It does everything its supposed to, although I am having an...
View Article2005 Walker MBSD hydro issue or replacement
Good Morning, My name is Don and my father has an older Walker Tracter Model MBSD Serial 77953 and he is having trouble with the LH hydro pump. It doesn't drive anymore. I am very mechanically inclined...
View ArticleDixie Chopper Generac 27hp surging
hello all. I have a 2010 Dixie Chopper Silver Eagle I bought at the end of last year. They guy had it as a backup mower and it ended up sitting around for a few years. Only has 20 hours on it and it...
View ArticleDixie Chopper Generac 27hp surging
hello all. I have a 2010 Dixie Chopper Silver Eagle I bought last year. They guy had it as a backup mower and it ended up sitting around for a few years. Only has 20 hours on it and it look like new....
View Article2008 Dixie chopper 2550 silver eagle
My Dixie motor shuts down when I release the parking break. I replaced the seat switch thinking this was most likely it no luck I then replaced the break switches no luck where should I look next?
View ArticleScag pro v walk behind
I recently came across a 52" pro v walk behind for $1000. It has the kawi motor on with roughly 1500 hrs. The mower seems in decent shape and owners says it just quit and won't turn over. Would this be...
View ArticleHelp the newbie!!!!
Just bought a craftsman pressure washer with a Briggs and Stratton engine not running for forty bucks. I I can smell gas and gets spark but won't start. Any ideas? Thank you.
View ArticleKohler CH750 speed hunting, backfire carb, runs backwards.
Hello, CH750 0026 spec. Installed new carb, test ran great for 45 minutes. Engine started surging. Could see the governor lever working. Smoothed out with choking the engine at 1/2 throttle. Will not...
View ArticleCh25 misfire
My scag turf tiger is dropping a cylinder. It was the first year they made the TT, so it's 17 or 18 years old. Koehler ch25 ser no. 27..... It was popping and missing and I found a blown intake gasket...
View Articlelazer z hydro pump question
i have a older lazer z with the horizontal engine anyway the hydro pump leaks a tiny oil by the rear cover the oil pump side where 2 bolts hold it. is there a part number just for that o ring? i dont...
View Articlebrand new walker t30i and issues..
Bought a brand new walker t30i with height adjuster and a few other options. Once i got it and brought it home an hour in the engine began surging. The height adjuster wasnt able to notch all the pin...
View ArticleScag with Kawasaki engine
I have a Scag Stt61A-KA23 / 61in cut / Kawasaki FD671D-AS01 engine. Now, I heard, read 2 different things about what compression should be. its been 70 to 170. what should it be?
View ArticleCub Tank with 24hp honda intermittantly won't start
The Facts: 2010 Cub Tank with 24 hp Honda (GXV670) When I turn the key most of the time I just get a click. After several tries sometimes it will start. If that doesn't work, I can rap on the starter...
View Article