Quick question,
Took the pump out of an exmark Lazer Z today and replaced the seals and gaskets. After I reassembled it I noticed that if you push the shaft (where the pulley goes) in toward the housing it moves about 1/8 inch. Feels like it's on springs because it pops right back out. Is that normal or should it be completely tight and not moveable except to turn?
Took the pump out of an exmark Lazer Z today and replaced the seals and gaskets. After I reassembled it I noticed that if you push the shaft (where the pulley goes) in toward the housing it moves about 1/8 inch. Feels like it's on springs because it pops right back out. Is that normal or should it be completely tight and not moveable except to turn?