Who can help with a Stihl Kombi tool?
I have a Stihl KM85 where the drive shaft started falling out last year when you remove the power head from the attachment. I was switching from the weedeater to the edger when I noticed it. I saw some...
View ArticleNo oil to bar and chain on Stihl 0:17
I have replaced worm gear on oil pump under clutch there is a slow leak it still has half a tank oil after sitting couple months is there a gasket I need to replace inside there or r other issues possible
View ArticleOlder Bobcat hydro walkbehind question
I am wondering about adjusting the hydros on this older mower (930307). I have never owned a Bobcat hydro and I can't seem to get the hydros adjusted right. When I bought it the guy didn't know what he...
View ArticleM48 cub cadet starting
i have a 2005 cub cadet m48 tank 20 hp Honda vtwin wont start on its own it will work and run fine once it starts but getting it started takes a battery charger . I've changed the starter and got the...
View ArticleTransaxle zt 3400
Hi guys.im just wondering what you think about this. .I'm just reading up on the maintenance on the bobcat quickcat 36.. On the transaxles when you do u the first 100hr oil change isn't there a bolt...
View Article2007 ExMark Lazer Z with PG pumps leaking
Running a 2007 ExMark LHP27KC565 with around 700 hrs. Did normal fluid and filters last winter, no issues. Both hydro pumps started leaking late summer, maintained levels and finished the season. They...
View ArticleSuper Z PTO Won't Engage
I have a 2009 or so Hustler Super Z 54 Kawi that has never had problems with blade engagement. I have only had it since last fall but no signs of clutch failure that i noticed. (Heating up and quitting...
View ArticleSkag Tiger Cub starting issue.......ideas?
Scag Tiger Cub (2002 year model) 900 hrs. 19hp Kawasaki. I've owned since new. Just recently has developed a starting problem. When I turn the ignition....I get nothing (no click, nothing). Battery is...
View ArticleCant loosen bypass valve Turf Tracer
I have a turf tracer, and it was cold the other day and I couldn't get it started. I released the bypass screw on the right side but couldn't get the left side loose, I tried with quite a bit of force...
View ArticleSnapper sr1433 Kohler 14hp command rider ovc
My engine will not turn over when you turn the key the solenoid clicks but that's it.Use a screwdriver on solenoid and motor acts like it wants to crank . Have tried turning by hand won't turn
View ArticleReplace Spark Plugs
I bought a used Scag belt 36" walk behind with a B&S Vanguard 16 HP engine and 90 hrs. I picked up a maintenance kit and did everything but the plugs today. My question to you.... Should I bother...
View ArticleMy 23hp Briggs and Stratton is hard to crank.
When I try to start the engine it stops at the first compression but once past the first compression it turns over very well and cranks right up. I adjusted the valves and put new battery and spark...
View ArticleHusqvarna 125B Blower - Fuel Line
Hi all, I ordered and replaced the fuel line, fuel filter and bulb on my Husqvarna 125B leaf blower. (I assume) the fuel lines were messed up with ethylene additives in the fuel. I am almost certain...
View ArticleGrasshopper Kubota Radiator
OK folks...I have had the radiator from my Grasshopper 928D2 to the radiator shop two or three times for repair and it is leaking again. Think I've gone as far as I can with it and need a new one....
View ArticleToro Z Master/Kohler Command 27Hp OVERHEATING
In need of major help/suggestions I have a 2008 Toro Z master with a Kohler command 27hp engine, I have noticed slight lack of power (Bogging) and excessive heat from the exhaust even at idle (Glowing...
View ArticleNeed new air compressor!
So I bought an air compressor from tractor supply a few years ago. The compressor just locked up one day so I took it back and they gave me a new one. That was only about a year ago. It did the same...
View ArticleTimemaster 20199 needs new motor
Hi, I'm in the middle of a tear down of the briggs from my timemaster and it looks like it needs too many parts to be functional again including cylinder honing. Does anyone have recommendations on...
View Article19 HP Kaw on Bunton EstatePro running issues
I have been having an ongoing issue with this mower, it's got right at 400 hrs. It will run perfect for about 5-10 minutes until it seems like it's good and hot, then it starts chugging or surging like...
View ArticleEngine trouble
wss wondering if anyone had any suggestions?i have a 19 hp Kawasaki on a Great Dane mower.just had lower crank case and head gaskets replaced,they grinder the valves and replaced valve seals now that I...
View Article