18hp briggs help wont start z spray
Just purchased older z spray 1400 hrs. Has 18 hp briggs that will not start. Will start off starting fluid but not stay running.. Its gettin fuel pushed out of the fuel pump It's getting spark because...
View ArticleRedmax blower eb7001 seems to lose power and won't start until cool
Hello Everyone, I think the issue with this blower may be more serious than when I posted last year. It gave me trouble at the end of last season on my last lawn and as a result of advice here, I...
View Article1996 Gravley Pro 50 Hydro Walk Behind
Help. I knew I was asking for a headache, but $200 later here I am. this mower is pristine, no rust any where even inside of deck is still original bright orange. but model number 988068 ser number...
View ArticleAny cross reference for Kohler ecv860 O2 sensor?
Have a 2018 cheetah with a Kohler 29 efi and I'm pretty sure the oxygen sensor is bad. It spits and sputtering with black smoke out the exhaust. Unplug O2 sensor and it runs perfect. It had a Delphi...
View ArticleStihl br320 backpack blower no start
Last season the blower was working just fine on one property and at the next won't start. It has new: plug, carb, fuel filter and lines. It has good spark and it's getting fuel. Just in case it wasn't...
View ArticleTuff Torq 10SA Pump
Need some help. Have a 48 in. C.C. Recon with a bad pump. Tuff Torq telling me they have parts but can't sell them and to call O.E.M. They tell me they have no parts diagram to give me numbers for what...
View ArticleKohler command pro ECH749-3063 issues starting
New here and hoping someone has some ideas. 2015 Scag Turf Tiger (STT61V-26CH-EFI) with the kohler 26.5hp ECH749-3063 engine. It has an issue starting. Sometimes I have to try to start it 10 times and...
View ArticleThinking about buying a suspension platform for my mower
I’m thinking about buying a suspension seat platform for my Dixie Chopper mower. It’s only $139 so I’m thinking about getting it. I would like to see if anyone has bought one and what they think about...
View ArticleHelp with my skid sprayer pump
Got a Kohler powered with hypo d30 pump. Went to clean out the tank after spraying and I ran out of water in the tank. Added some more to rinse and nothing coming out of the hose. I looked and the...
View Article16 hp briggs carburetor bolts siezed
I bought a used z spray. Has the 16 go Briggs motor. Will not run. Need to clean/rebuild, or replace the carb. I can't get them unstuck.. the nuts came off but the carb will not slide off the bolts....
View ArticleASV RC30 Drive Issues
Hi All, Wonder if anyone can help. I have purchased a used ASV RC30. I believe there is an issued with the drive motor on the left hand side. It had drive when cold but after about 30 mins it loses...
View ArticleBroken bolt problem
I have a broken bolt on recoil housing on a Scag 36 inch walk behind hydro. Will this affect the engine of I run it? What would or could happen if I ran it? What is the fix for this? Thanks.
View Articlerpms 25hp kawasaki
I got a 25hp kawasaki(horizontal). I'm having to reset the rpms every other day cause it either loses rpms or gain rpms. I can't figure out whats going on, the speed adjustment slide is not coming...
View ArticleScag Turf Tiger Repair
I got a Scag Turf Tiger non running for free from a friend. I use to use this mower all the time so I’m familiar with it. It has a Kawasaki FD661D on it with 952 hours. I was told it had firing/timing...
View ArticleKawasaki FS730V Carb dripping fuel
Pulled out the Bad Boy for the first time this season and noticed fuel dripping off carburetor... right onto the muffler! Only ran it for a minute so no fire thankfully. The fuel line is intact so...
View Article37 EFI oil question
So I know it’s recommended to not use full synthetic oil until 100 hrs, what should I use for my 37 EFI? Currently I’m running 10w40 Kawasaki part synthetic, would I be ok to use the Kawasaki 20w50...
View ArticleEclip installation issues on wheel swap
Hey All anyone have issues installing their eclip / e-clip back onto their mower after taking off the wheel? I’m having a heck of a time after removing my wheel to replace my brake bands and getting...
View ArticleScag SWZT Hydro Fan
Anyone know how to get the damn things off? i have one with some broken fins. I cant even get it off with an impact. it spins a little when i hit it with the impact but it should still crank loose. Is...
View ArticleKaw FX1000V 37DFI dead!!
I have a 2016 Ferris 3200z with a Kaw 37HP DFI with 175 hours. Last year it started acting strange and would over rev, randomly and also drop rpms, randomly. Doing my Google research I didn't find much...
View Article