Picked up an older scag. Need a little help. First the spindle bearings are shot. I have new bearing but I'm not 100% clear on how they go in. To remove the old bearing I remove the blade, remove pulley by screwing the two bolts into the collar then so I remove all 4 clips 2 top and 2 bottom? Which way do I drive out the bearings and the center shaft? I want to do this on the machine.
Second question, it's a Kohler cv14t engine. It's running at about 3400 with the throttle adjuster plate...
Scag sw36-13kh help needed
Second question, it's a Kohler cv14t engine. It's running at about 3400 with the throttle adjuster plate...
Scag sw36-13kh help needed