Call me a newbie if you wish, but I've never had a spindle apart before, or replaced one.
I am restoring a 61" deck and had to remove all the pulleys to sand / prime / paint, which was a chore, until i bought a good large puller.
Anyway, I took the right blade pulley off and the shaft that holds the blade basically fell through. when i took the others off the shaft stays exposed. It also appears to have no bearing or anything inside because there is a race or guide that just appears to...
Is this a bad spindle?
I am restoring a 61" deck and had to remove all the pulleys to sand / prime / paint, which was a chore, until i bought a good large puller.
Anyway, I took the right blade pulley off and the shaft that holds the blade basically fell through. when i took the others off the shaft stays exposed. It also appears to have no bearing or anything inside because there is a race or guide that just appears to...
Is this a bad spindle?