Just got a new engine (FH721D-A08) to replace my old Kawasaki FH680D A04, I found out the FH721D-AS08 has an inch longer engine shaft. The vendor suggests to shorten the shaft using an angle grinder with a cutting wheel.
Has anyone done this? There are other small issue with the new replacement engine, but I got around it by using the parts from the old engine.
I was surprised not much info on the internet considering there are lot of issue with the older design with the air cooling...
Replacing JD z737 engine with Kawasaki FH721D-A08
Has anyone done this? There are other small issue with the new replacement engine, but I got around it by using the parts from the old engine.
I was surprised not much info on the internet considering there are lot of issue with the older design with the air cooling...
Replacing JD z737 engine with Kawasaki FH721D-A08