Hi all,
I am in the midst of replacing my pto switch because the pto/blades are not engaging and everything else seems fine. I noticed that the white plug housing for the 3 yellow/red/black wires was melted, although it looked like it had been like that for a while. I made the mistake of pulling the wires out to clean the tar off of them and forgot how it was wired. They plug into the plug that says it is for Reg/mag/solenoid, but there are also 4 wires. Not sure if the was a jumper in there...
Grasshopper 225 wiring - reg/mag/solenoid plug
I am in the midst of replacing my pto switch because the pto/blades are not engaging and everything else seems fine. I noticed that the white plug housing for the 3 yellow/red/black wires was melted, although it looked like it had been like that for a while. I made the mistake of pulling the wires out to clean the tar off of them and forgot how it was wired. They plug into the plug that says it is for Reg/mag/solenoid, but there are also 4 wires. Not sure if the was a jumper in there...
Grasshopper 225 wiring - reg/mag/solenoid plug