Briggs and Stratton
Model: 286707
Type: 0413 01
Flat head
Valve Specs
0.005-0.007 Intake
0.009-0.011 Exhaust
I bought this motor a few years back used. Finally decided to do the valve adjustment. It is the same process on pretty much all flat heads correct? Get motor to TDC compression or slightly past, check valve lash, if out remove valve(s), lap valves and grind valve(s) to get within specifications?
So I am starting with the following:
Intake - zero clearance (0.0015 will not fit)...
Valve Adjustment on Briggs 280000 Series
Model: 286707
Type: 0413 01
Flat head
Valve Specs
0.005-0.007 Intake
0.009-0.011 Exhaust
I bought this motor a few years back used. Finally decided to do the valve adjustment. It is the same process on pretty much all flat heads correct? Get motor to TDC compression or slightly past, check valve lash, if out remove valve(s), lap valves and grind valve(s) to get within specifications?
So I am starting with the following:
Intake - zero clearance (0.0015 will not fit)...
Valve Adjustment on Briggs 280000 Series