Hello,
I have a 52" Exmark HP Z that I recently purchased. The unit has 1650 hours on it with original hydraulics. I'm new to zero turns (skilled with a Toro Proline T bar) but the unit is very touchy in terms of steering at lower speeds. It's almost impossible to mow next to anything. Higher speeds seem to be much easier.There is no fluid leaking from either of the motors.
I have disassembled the linkage all the way from the control lever to the pump. Replaced dampers and rod ends. Done...
Exmark Wheel Motor Slop
I have a 52" Exmark HP Z that I recently purchased. The unit has 1650 hours on it with original hydraulics. I'm new to zero turns (skilled with a Toro Proline T bar) but the unit is very touchy in terms of steering at lower speeds. It's almost impossible to mow next to anything. Higher speeds seem to be much easier.There is no fluid leaking from either of the motors.
I have disassembled the linkage all the way from the control lever to the pump. Replaced dampers and rod ends. Done...
Exmark Wheel Motor Slop